Install Overlay And Classic Series Custom Panels - KitchenAid Bottom-Mount Built-In Refrigerator Installation Manual

IMPORTANT:
Install the custom handles prior to installing the panels on
the refrigerator. For more information on KitchenAid
custom handle selection, refer to the KitchenAid Catalog,
visit www.kitchenaid.com, or call 1-800-422-1230.
In Canada, visit www.KitchenAid.ca, or call
1-800-807-6777.
Create custom door overlay panels according to the
specifications in the "Overlay Series Custom Panels"
section.
KitchenAid is not responsible for the removal or addition
of molding or decorative panels that would not allow
access to the refrigerator for service.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator
door(s) and freezer drawer.
2. Open the refrigerator door(s) and freezer drawer and remove
the trims and corner caps on each door as shown.
A
B
C
A
A. Corner caps
B. Refrigerator door trims
C. Freezer drawer trim
24

Install Overlay and Classic Series Custom Panels

3. Slide the custom panels into the trims on the refrigerator
door(s) and freezer drawer, making sure that the backer panel
fits into the hinge side trims.
A
A
B
4. Reinstall the trims and corner caps.
5. Remove the protective skin from the screw covers. Snap the
screw covers into the handle trim section.
A
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up; then pull straight out. Place the top grille
panel-side down on a soft working surface.
A. Panels
B A
A. Top grille
B. Cabinet side trims
A
B