Before Use; Starting And Stopping - Flymo EasiCut 420 Original Instructions Manual

B1
C1
Before starting your hedge trimmer.
• Securing the cable in the Belt Clip helps keep the
cable away from blade.
1. Push up the hook on the Belt Clip (B1)
2. Place the rear section of the Belt Clip behind your belt
(B2)
3. Push down the hook on the Belt Clip to secure it onto
your belt (B3)
E
2
1
J
1
To start your hedge trimmer
EasiCut 420/450/510
1. There are three switch levers fitted to your
Hedgetrimmer.
2. Main switch lever (E1) and one other switch lever
need to be held in the operating position (E2 or F1)
for the product to start.
To start your hedge trimmer
EasiCut 600XT
1. There are four switch levers fitted to your hedge
trimmer.

Before Use

B2
C2

Starting and Stopping

F
1
K
B3
D
4. Form a loop in the mains cable and push the loop
through the hole in the Belt Clip (C1) ensuring the coil
in the cable is close to the clip.
5. To secure, position the loop over the hook and pull
back (C2).
6. Connect to mains and switch on
7. Remove blade cover (D).
G
1
3
2
L
2. To start, push forward the lock-off button (G1),
squeeze the main switch lever (G2), release lock-off
button.
3. Main switch lever (G2) and one other need to be
held in the operating position (G3, H1 or J1) for the
product to start.
To stop your hedge trimmer
• Move hedge trimmer away from cutting area before
stopping.
1. To stop, release any switch lever.(K, L)
H
1