EasiCut 420/450/500/510 instruction manual EasiCut 600XT instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 01325 300303...
Page 3
If not used properly this product can be dangerous! This product can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. The operator is responsible for following the warning and safety instructions in this manual and on the product.
Page 4
7. Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo re- placement cable. 8. Always wind cable carefully, avoiding kinking.
Page 5
CABLES IMPORTANT • Use only 1.00mm size cable up to 40 metres length maximum. Maximum rating : 1.00mm size cable, 10 amps 250 volts AC. • YOUR HEDGETRIMMER IS SUPPLIED WITH CABLE WIRED DIRECTLY INTO THE PRODUCT. 1. Mains Cables and Extension Cables are available from your local Approved Service Centre.
3. Push down the hook on the Belt Clip to secure it onto your belt (B3) To start your hedge trimmer EasiCut 420/450/510 There are three switch levers fitted to your Hed- getrimmer. Main switch lever (E1) and one other switch lever need to be held in the operating position (E2 or F1) for the product to start.
1. Inspect area to be cut before each use - remove ob- jects which can be thrown or become entangled in the cutting blades. 2. Always keep the hedge trimmer in front of your body. Hold handle firmly with both hands and stand in a se- cure and stable position.
Service Centre will require proof of purchase. All of the centres listed stock genuine Flymo Spare Parts. NOTE: Our Service Repairers act on their own behalf and are not empowered to commit or legally bind Husq-...
Husqvarna UK Ltd., Aycliffe Industrial Park Newton Aycliffe, Co. Durham, DL5 6UP, England Declare under our sole responsibility that the product(s); Category...Hedgetrimmer Type(s) ...EC420, EC450, EC500, EC510, EC600 Identification of Series...See Product Rating Label Year of Construction...See Product Rating Label Conforms to the essential requirements &...