Before Use; How To Trim And Edge; Manual Line Feed - Flymo CCT250 Instruction Manual

J
2
1
L
M
2
1
P
manual line
feed button

How to trim and edge

K
N
1

Manual line feed

• WARNING
• The use of eye protection is recommended.
Do not lean over the trimmer whilst trimming or
edging, objects may be thrown by the cutting line.
Do not allow cutting head to rest on the ground.
Do not overload your trimmer. Overloading can be
avoided by making sure the motor speed does not
drop unduly.

• BEFORE USE

Make sure that both lines are fed out.
• Make sure motor is up to full speed before
trimming or edging.
How to trim
• The switchbox is provided with a lock-off button
(J1) to prevent accidental starting.
1. To start, press lock-off button (J1), squeeze the switch
lever (J2), release lock-off button.
1. Hold as illustrated in Fig J.
2. To start, squeeze the switch lever.
3. Cut with nylon line at an angle using the tip. (K).
4. Swing trimmer in and out of the cutting area taking
small cuts (L)
5. Line is fed out automatically every time the trimmer head
stops rotating and returns to operating speed.
• Extra line can be fed out manually as described in
Manual line feed
6. To stop your trimmer release the switch lever.
How to edge
1. To convert to edging mode, press button (M1) and
twist head (M2). An audible "click" will confirm that the
head is locked.
2. Hold as illustrated in Fig J.
3. To start, squeeze the switch lever.
4. Rest edger on wheel for extra stability and line up the
edge of the lawn with the two indicators on the guard
(N1). Edge in direction indicated in Fig N.
5. To stop your trimmer release the switch lever.
6. To return to trimming mode, press button and twist
head back the opposite way. An audible "click" will
confirm that the head is locked.
To manually feed the nylon line (P)
1. If required line can be fed out manually.
2. To operate, press and release manual line feed button,
whilst gently pulling on the line until it reaches the line
cutter.
3. If the line extends past the line cutter, too much line
has been fed out.
4. If too much line is fed out, remove the spool cap and click
spool anti-clockwise until the line is at the desired length.