3. O
PERATION
Note:
The Mania SCX600/700 is supplied in DMX mode with its DMX
address set to 1. If want to operate the fixture without a DMX
controller, you need to set the fixture to stand-alone music trig
or auto trig mode before use (see "Selecting DMX, music trig
or auto trig operating modes" on page 15).
G e t t i n g s t a r t e d
Powering on
Once the Mania SCX600/700 is correctly and safely installed, power on at
the fixture's power on/off switch. The fixture will start up and reset. The
display will show the following messages:
1. -
2. Fixture name
3. Software version number
4.
If the fixture resets successfully, it will display either its DMX address,
mode).
If any other message is displayed, the fixture has detected an error (see
"Error messages" on page 32). If this occurs, switch off, wait a few
seconds and switch on again. If the error message appears again, consult
your Martin dealer.
Control panel and menus
You can set the Mania SCX600/700's DMX address, modify the fixture's
personality and control effects manually using the menus in the control
14
-
(stand-alone music trig mode) or
Mania SCX600/700 user manual
(stand-alone auto trig