Galley; Sink Drains; Cook Stove; Lighting Instructions - Bavaria 36 User Manual

Revised/Updated March 2011
ESCAPE
system. A discussion of heating is contained in the "Heating" section. To turn on
the Espar Diesel heater to make hot water, simply turn the rocker switch to the on position.
The red LED light should come on. If cabin heat is wanted the thermostat must be adjusted
as discussed later. It normally takes about 20 minutes for the Espar unit to run thru its start
up cycle so allow plenty of time before expecting hot water. Remember using the Espar
heater will not fill the Hot Water tank with a reserve of hot water. There are no other steps
required to obtain hot water for the water facets in the kitchen, bathroom and swim platform.
When the system is going to be turned "OFF" (shut down) you may still hear the fan and
pump running in the aft cabin. This is normal.
Instructions for cabin heat see section marked Heating.

GALLEY

Sink Drains

The drains on the galley sink connect to individual through-hull values. The galley through-
hull valves are located directly under the sinks.
The valve should be CLOSED if ESCAPE will be sailed in heavy weather conditions and
severe healing is expected, this will prevent back filling of the sink and avoid possible water
overflow into the cabin.
Caution
Galley Stove
The stove operates on propane (LPG) fuel. The fuel tank is mounted in a self-draining case
molded into the deck on the port side of the walk-through transom. The tank may be difficult
to remove but a little finesse will do the job.
IF ANY FUMES ARE DETECTED at ANY TIME WITHIN THE BOAT, the electrical
switches should be turned off and the boat adequately ventilated.
A standard valve is located on top of the tank. On the bulkhead above the stove is a gas
control panel. The control panel has an on/off switch to control the gas flow. When the
switch is on a green light on the panel will be lit. When the stove is not in use, the switch
should remain off. If the yacht is going to be left for a long period of time the gas should be
shut off at the tank.
Make sure the individual stove knobs are closed before the bottle valve is open.
If there is a leak turn off the gas valves and call for repairs.

Lighting Instructions

Open the valve on the tank and activate the switch above the galley.
10