Powerware 5115 User Manual page 24

Installation
NOTE
This is a typical setup;
your setup may vary.
18
Powerware
®
Figure 2. Typical UPS Installation (120V Model Shown)
3.
Plug the UPS power cord into a power outlet.
Verify that the circuit has an upstream overcurrent protection of
15A for 120V models or 10A for 230V models.
4.
Plug the equipment to be protected into the UPS output
receptacles.
NOTE
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
5.
Press and hold the
(approximately two seconds).
µ
The indicator illuminates indicating that power is available
from the UPS output receptacles. The UPS conducts a self-test
and enters Normal mode.
If the alarm beeps or a UPS alarm indicator stays on, see Table 9
on page 40.
NOTE
The batteries charge to 90% capacity in approximately 3 hours.
However, it is recommended that the batteries charge for 6 to 24 hours
after installation or long-term storage.
5115 Tower UPS (500–1400 VA) User's Guide
1
Connect communication
cable from computer to
UPS (optional)
4
Connect equipment to UPS
button until you hear the UPS beep
05146640 Rev C www.powerware.com
S
5
Press the ON button
(on the front panel)
2 & 3
Connect UPS to power