Step 4: Wire The Speaker; Step 5: Secure The Seismic Tab Connection Point; Step 6: Test System Operation - Electro-Voice EViD 3.2 Owner's Manual

Attach both logo caps as shown in Figure
11 after tightening and securing the speaker.
EV logo cap
(small)
Figure 11: Attach logo caps

Step 4: Wire the Speaker

Connect the wires to the speaker at the
back terminal plate observing the polarity
of the connections. The push-terminals
accept banana connector plugs.
Step 5: Secure the Seismic Tab
Connection Point
The rear of the enclosure includes an eye-
bolt for connection to a seismic restraint.
Connect it to a properly rated hardware fit-
ting that is securely installed independent-
ly of the SAM™ bracket. Even if your local
construction code does not require the
installation of secondary support, its use is
highly recommended for further security.
6
EV logo cap
(large)
Connect seismic
security cable
Figure 12: Secure seismic security cable

Step 6: Test System Operation

After all connections are made, test the
complete system operation. Appendix C
(page 14) contains a troubleshooting table
to assist in locating many speaker-related
problems.
Figure 13: EVID™ system
Product Description
EVID Owner's Manual