Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Daymak Falcon RLC-11V
Summary of Contents for Daymak Falcon RLC-11V
-
Page 2: Table Of Contents
Contents Contents Contents Contents 1. Introduction…………….………………………………....2 2. Version…….……………………………………………..………….3 3. Description………………………………………………………….3 4. Self-Balancing Transporter…………………………………………4 4.1 Handlebar………………………………………………………4 4.2 Display panel…………………………………………………...5 4.3 Wheel Guards ………………………………………………….5 4.4 Wheels………………………………………………………….5 4.5 Foot Pads……………………………………………………….6 4.6 Battery………………………………………………………….6 4.7 Remote control…………………………………………………..7 5. Operation ……………………………………………………………7 6. Operational Conditions and Maintenance …………………………..8 Annex 1 …………………………………………………………. -
Page 3: Version
Notice Do not ride on surfaces that are slippery, wet or obstructed, otherwise the rider may lose balance and fall. 2. 2. 2. 2. Version Version Version Version Version number Release date Remarks 10/2012 Original version Note This booklet is subject to change without notice. Ensure you are familiar the most up to date version, please visit: http://www.daolibai.com 3. -
Page 4: Handlebar
4. 4. 4. 4. The Self-Balancing Self-Balancing Transporter Transporter The Self-Balancing Self-Balancing Transporter Transporter Operation of the Self-Balancing Personal Transporter, Precautions and Components. Handlebar: Handlebar: 4.1 Handlebar: Handlebar: The handlebar maintains balance and controls the direction of the vehicle. The front and rear of the handlebar is shown below: The height of the handlebar can be adjusted to suit the rider. -
Page 5: Wheels
Caution During power-up, riding, and shutdown operations, always hold the handlebar firmly or a loss of balance and possible injury may result. Display Display Panel Panel 4.2 Display Display Panel Panel The Display Panel shows information about the Transporter’s operation. 4.2.1 Install two batteries, the battery light does not shine . - Page 6 Foot Foot pads pads 4.5 Foot Foot pads pads The foot pads support the rider’s feet. While riding both feet should always be positioned in the middle of the pad as shown below. Battery 4.6 Battery Battery Battery The battery provides power to the Self-Balancing Transporter. The battery voltage is 70VDC. Do not open the battery compartment or the vehicle’s control panel, as there is a danger of electric shock.
-
Page 7: Battery
Warning In the case of the vehicle not being in use for an extended period, please fully charge the batteries once every 30 days. Otherwise irreversible damage to the battery may be caused. Long Long time time time no no no no use, use, use, disconnect... - Page 8 5) Holding the handlebar with both hands move your body weight slowly forward and the vehicle should move forward slowly; move your body weight backward, and the vehicle should stop. The vehicle’s forward and backward movement should be controlled and change according to your body movement. 6) Tilting the handlebar controls the direction of the vehicle.
- Page 9 b) Handlebar Suspension Gas Springs: Replace annually or each 1,000Km c) Tyres: replace both tyres if the tread depth less than 0.5 mm. d) Gearbox oil: Change Oil each 2,000km. Tianjin Tianjin Tianjin Tianjin Rijiang Rijiang Rijiang Rijiang Technology Technology Technology Technology Company Company...
-
Page 10: Annex
Annex Annex Annex 1 1 1 1 Annex use of of of of the remote remote control control The use the remote remote control control Definition Definition Definition Definition： The top left button of the remote control for the 【power button】. the lower left button 【mode key】. - Page 11 See picture C 2. 2. 2. 2. Power Power Off: : : : Power Power Off In the standby mode. Hear the buzzer "beep" sound when press [power button] key release, display Quanmie already Power off. See picture D 3. 3. 3. 3. Locking Locking Locking Locking：...
- Page 12 Riding for the first time or a long time after lying , It need to initialize the balance point data..In the power off state，Press the 【power button】+ 【mode key】key，About two seconds to hear the "beep, beep, beep.Digital control loop display "--------"That is being corrected equilibrium point .The scooter should make the platform level，Handle placed in the middle position，About five seconds.
- Page 13 （4） Press the the【 display key】 corresponding data "increase" (5) Power 1th lights . Represent control turn left platform step ； Power 2th lights ， Represent control turn right platform step；Power 3th lights Represents the maximum amount of abatement platform ， Power 4th lights ， Represents the maximum amount of elevation platform.
- Page 14 picture picture picture H H H H See picture this this moment moment moment: : : : this this moment (1) press 【mode Key】 time "reduce". (2) Press 【 power button 】 to cancel the setting ， Retain the original value. (3) Press 【locking keys】...
Need help?
Do you have a question about the Falcon RLC-11V and is the answer not in the manual?
Questions and answers