Lp Conversion Instructions - Travis Industries 864 Clean Face Installation Manual

Finalizing the Installation

LP Conversion Instructions

Install the conversion kit prior to installing the gas line to ensure proper gas use.
The GSR Stepper Motor Kit (SKU 94400999) is required for converting this appliance to LP. The
kit contains the stepper motor (regulator), torx wrench, and pilot orifice. The burner orifices and
burner gaskets are shipped with the appliance.
1 Remove the glass (see page 39). Remove the logs and embers (if installed - page 40)
2 Remove the burners following the directions below.
Lift the rear burner, slide it to the right, and lift it from the firebox. The burner has a bracket that
inserts over two pins behind the burner. When replacing the burner make sure it is properly located.
Lift the front burner, slide it to the right, and lift it from the firebox. When replacing the burner make sure it is
properly located.
The rear burner air shutter support will need to be removed to access the orifice. Remove the support and
place it aside.
Travis Industries
(for qualified installers only)
4140613
47
100-01376