Toshiba Tecra A9 Series User Manual page 55

NOTE
2
3
Memory slots
(Sample Illustration) Removing the memory module
4
5
6
Downloaded from LpManual.com Manuals
Do not try to remove a memory module with the computer turned on.
You can damage the computer and the memory module.
Do not remove the memory module while the computer is in Standby
or Hibernation mode. The computer could hang up the next time you
turn it on and data in memory will be lost. In either of the above
cases, the Standby configuration will not be saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any Key to Continue
If the computer hangs up when you turn it on, perform the following:
Press the power button and hold it down for at least ten seconds,
then turn the power on again.
If your system has the memory modules stacked on top of one
another, you must remove the top module first before
removing/installing the bottom module.
Pull the latches away from the memory module.
The memory module pops up slightly.
Gently lift the memory module to a 30-degree angle and slide it
out of the slot.
Replace the memory module slot cover and secure it using the
screw.
Re-insert the main battery. For more information on inserting
the main battery, see
Turn the computer right side up.
Getting Started
Adding memory (optional)
Front of computer
"Inserting a charged battery" on page
55
110.