Scope Of Delivery; Usage Of External Usb Devices; Receiver; Front Panel - THOMSON THT700 User Manual

WArninG
noTe
Menu
Move to

1.4 scope of delivery

• 1 receiver
• 1 quick installation guide
• 1 remote control
• 1 power adapter
• 1 cable 3.5mm jack - 3 RCA (Cinch)
• 2 batteries (ААА)
noTe:

1.5 usage of external usb devices

• It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
specifications, it might not work properly.
• THOMSON cannot guarantee compatibility with all types of USB storage devices.
• It is advised not to store important information on USB storage devices used with the receiver. Always
make backups of data on your USB storage device before using it with this receiver. THOMSON will not
take responsibility for any loss of information or circumstances caused by loss of information.
• Please ensure that either the USB device is already formatted to FAT32.

2.0 receiver

2.1 front panel

1. slot for smart-card:
2. remote sensor: Receives signals from the remote control.
3. indicator LeD:
4. usb port:

2.2 rear panel

1. ir
2. AnT in
3. hDMi
4. Av
5. s/PDif (coaxial) To connect the digital audio amplifier/ home theatre.
6. Dc PoWer
P4
receiver
Indicates warning information.
Indicates any other additional important or helpful information.
Represents a button on the remote control or the receiver. (bold characters)
Represents a menu item within a screen. (Italic characters)
The batteries must not be recharged, disassembled, electrically short-circuited, be
mixed or used with other types of batteries. If rechargeable accumulators instead of
batteries are going to be used, we recommend using (e.g. NiMH) types with low self-
discharge to ensure long time operation of remote control.
The slot is located on the lower bottom side of the receiver. It is intended for
service functions only and is not used during operation.
Lights up in green in operating mode and red in standby mode.
For connecting an external USB storage device.
To connect an infrared extender (not included)
To connect to the antenna
To connect an HDMI cable with your HDTV
To connect the corresponding RCA inputs of the TV or analogue audio system
with your receiver.
To connect the supplied power adapter with the receiver (Input 110-240 V 50 ~
60 Hz/output 12 V/1.0 A DC max ).
Fig. 1
Fig. 2