Table of Contents
Advertisement
Normally the software of the receiver is detected automatically via the broadcasted signal. In this case you
can decide if you want to update the software now or after you switch into standby.
While processing the OTA the loader is displayed at the screen during the software update. The update
process is displayed as a green indicator with the progress bar displayed on the left. After completing the
software update the receiver will reboot automatically and switch to the last viewed channel.
noTe:
• Please wait until the software update is completed. Avoid any actions until the update process is finished
or an error message appears.
• Do not unplug the receiver from the mains until the software update is completed.
• Do not disconnect the antenna until the software update is completed.
Failure to follow the above instructions can lead to receiver failure and as a result the warranty will void.
6.3.4 remove the usb device
This menu only appears if a USB device is connected. Select it and press ok to safely remove the USB
device from your receiver.
6.4 information
This menu mainly contains information on the receiver hardware and software as well as the embedded
CA system. Certain circumstances might occur when you need this information.
6.4.1 information
Find technical information about this receiver as model, hardware and software versions. This information
might be asked for if you contact the service or hotline.
6.4.2 service status
In this menu you will find information about the service descrambling status.
6.4.3 Loader status
In this menu you will find information about the software loader status, date and time of the last software
update.
6.4.4 Product status
This menu shows the current subscription status information of the product(s) you have subscribed to by
your operator as well as date and duration of the subscribed product.
6.4.5 client status
This menu displays all details of the embedded conditional access system and its capabilities.
6.4.6 region status
If available, this menu displays specific regional data according to the country this product is developed
for.
6.4.7 Mailbox
This menu contains mails from the operator. Use pq to move in the mail box and ok to read content.
7.0 TroubLeshooTinG
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It may cause a
dangerous situation and warranty will be void.
P14
TroubLeshooTinG
Advertisement
Table of Contents
