Docomo User Manua User Manual page 169

✔INFORMATION
If the software is not updated when the update notification is
received, (software update available) appears on the
status bar.
If software update at the preset time could not be performed,
the software update will be performed at the same time the
following day.
Software cannot be updated automatically when the Auto-
update setting is set to [Manual Update] or while updating
software by Now update.
Updating software immediately
Software update starts immediately.
There are 2 ways to activate software update: activating
from Software update notice screen and activating from the
menu.
<Example> Activating software update from the setting
menu
1
From the Home screen,
phone] [Software Update]
2
[Start the software update] [Yes]
If software update is not needed, [No update is needed.]
is displayed.
Activating from Software update notice screen :
Software update notice screen [Start the software
update]
[Settings] [About
Display
167
3
Rewriting starts automatically approximately
10 seconds after [Ready for update. Please
refrain from starting other application.] is
displayed
Rewriting starts when you tap [OK].
While updating the software, all key operations become
disabled and updating cannot be canceled.
When the software update is complete, the terminal
restarts automatically and the Home screen is
displayed.
❖
Post-update display
When software update is complete, it is notified by
status bar. Open the Notification panel and tap the notification
to display the update completion screen.
on the
Appendix/Index