Docomo User Manua User Manual page 144

Using "Osaifu-Keitai compatible
service"
Access to each Osaifu-Keitai compatible service website etc. to
make necessary settings before using.
Osaifu-Keitai compatible services are provided by Osaifu-
Keitai service providers. For details on each compatible
service, contact the Osaifu-Keitai service provider.
1
On the website of Osaifu-Keitai compatible
service etc., select a service
If the initial setting of Osaifu-Keitai has not yet made,
the initial setting screen appears. Follow the onscreen
instructions to set.
2
Hold mark over a card reader
mark
IC card reader
✔INFORMATION
When reading/writing data, you need not activate Osaifu-
Keitai compatible application.
Powering on the terminal is not necessary, but if the terminal
remains powered off for a long time or battery is low, the
function may not available.
For non-subscriber to sp-mode, a part of Osaifu-Keitai
compatible service may not be available.
Using "
(Kazashite-Link compatible service)"
The dedicated application may be required to use Kazashite-
Link compatible services. Use "IC Tag/Barcode Reader"
application ( P51) to hold
device, a smart poster, etc.
❖
For notes when holding over the other
device
Pay attention to the following when holding the terminal over
a card reader, IC chip built-in device, etc.
Bring the mark close to the device slowly, do not hit it
strongly.
Hold mark horizontally over the center of the compatible
device. If scanning fails even with it held in front of the
center of the scanner, slightly lift up the terminal, or move it
backwards/forwards or to the left/right.
If there are metal objects between
device, scanning may fail. Putting the terminal into a case or
cover may affect communication. In that case, remove the
case or cover.
142
mark over IC chip built-in
mark and the other
Data communication