Hitachi C 12LSH Safety Instructions And Instruction Manual page 34

English
3 Position the crown molding so that the lower surface (B in Fig. 37) contacts the fence
as in Fig. 42.
1
Miter angle scale
Turntable
Fence
A
(3) Setting to cut crown moldings at positions 1 and 4 in Fig. 38 (see Fig. 43; tilt the head to
the right):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (B in Fig. 37) contacts the
fence as indicated Fig. 45.
(4) Setting to cut crown moldings at positions 2 and 3 in Fig. 38 (see Fig. 44; tilt the head to
the right):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
34
Head
Bevel angle scale
4
Fence (A)
Base
Fig. 39
B
Table on base
Fig. 41
Head
2
Fence (B)
Turntable
Fence
B
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
Bevel angle scale
3
Miter angle scale
Base
Fig. 40
A
Table on base
Fig. 42