Hitachi C 12LSH Safety Instructions And Instruction Manual page 19

Left bevel angle cutting
Direct angle cutting
Fence (A)
5. Confirmation for use of sub fence (B)
WARNING:
Turn
Left bevel angle
cutting
Sub fence (B)
6. Oblique angle
Before the power tool is shipped from the factory, it is adjusted for 0°, right angle, left
45° bevel cutting angle and right 45° bevel cutting angle with the 8 mm set screw, 8
mm bolt (A) and 8 mm bolt (B).
When changing the adjustment, change the height of the 8 mm set screw, 8 mm bolt
(A), or 8 mm bolt (B) by turning them.
When changing the bevel angle to the right 45°, pull the set pin (A) on the direction
shown in Fig. 12-b and incline the motor head to the right.
When adjusting the motor head to 0°, always return the set pin (A) to its initial position
as shown in Fig. 12-b.
Turn Right bevel
angle cutting
Sub fence (A)
Fig. 10
In the case of left bevel cutting, turn the sub fence (B) counterclockwise.
Unless it is turned counterclockwise, the main body or saw blade
may contact the sub fence (B), resulting in an injury.
Right bevel angle cutting
Direct angle cutting
Fence (B)
Fig. 11
This power tool is equipped with a sub
fence (A).
In the case of direct angle cutting and
left bevel angle cutting, use the sub fence
(A). Then, you can realize stable cutting
of the material with a wide back face.
In the case of right bevel cutting, raise
the sub fence (A) up as illustrated in Fig.
10 and then turn it clockwise.
This power tool is equipped with a sub
fence (B). In the case of direct angle
cutting and right bevel angle cutting, use
the sub fence (B). Then, you can realize
stable cutting of the material with a wide
back face. In the case of left bevel cutting,
raise the sub fence (B) up as illustrated
in Fig.11 and turn it counterclockwise.
English
19