Hitachi C 12LSH Safety Instructions And Instruction Manual page 24

English
CAUTION:
NOTE:
• Before starting to cut, align the main unit to the miter angle 0° and the
bevel angle 0° and hold down thier reset buttons for at least 0.2 second. If
you press the digital display switch to ON without aligning the main unit to
0°, then the figures appearing on the digital display and the main unit angle
will not match.
• The laser marker will not light up if the digital display switch is turned off.
(only on C12LSH)
• Do not use the main unit near equipment that generates electrical noise
such as generators. Electrical noise might cause faulty readings or operation
on the digital display.
Move the turntable left and right with
the side handle loosened and set it to
the correct position.
24
When operating the digital panel, have the motor head section at the
top limit position and the blade stopped.
Side handle
Turntable
Fig. 22-b
CAUTION:
If the figure shown on the
miter angle digital display
is different from the
positive stop angle (for
example, 45.0° → 45.5°,
31.6° → 32.0°) then the
positive stop has probably
deviated slightly from its
correct position. If this
happens, do as follows.
(1) Move the turntable left and
right with the side handle
loosened, and set the
turntable to the correct
position.
(2) If the figures on the display
and positive stop still do
not match, then return the
turntable to the 0° position.
Next move the turntable
left and right with the side
handle loosened as shown
in Fig. 22-b. After setting it
to the correct position 0°,
press the reset button
again as shown in Fig. 21.