Sub-Zero Wine Storage Installation Manual page 29

MODEL WS-30 INSTALLATION
Alignment
DOOR ADJUSTMENT
The door can be adjusted in and out, side to side tilt and up
and down.
To make adjustments, slightly loosening the two upper hinge
bolts on the upper hinge plate using a
the illustration below.
In and out adjustment | For a left-hinge door, using a
5 / " allen wrench, turn the adjustment bolt clockwise to
32
bring the handle side of the door inward, and counterclock-
wise to move the handle side outward. Reverse directions
for a right-hinge door.
Side to side tilt adjustment
3 / " wrench, turn the adjustment bolt clockwise to raise the
8
handle side of the door, and counterclockwise to lower the
handle side. Reverse directions for a right-hinge door.
Up and down adjustment
1 / " allen wrench, turn the adjustment bolt clockwise to raise
4
the door and counterclockwise to lower. Refer to the illustra-
tion below. Reverse directions for a right-hinge door.
UPPER
HINGE BOLTS
IN-AND-OUT
ADJUSTMENT
SIDE-TO-SIDE
TILT ADJUSTMENT
Door adjustment bolts.
1 / " wrench. Refer to
2
| For a left-hinge door, using a
| For a left-hinge door, using a
Up and down door adjustment.
Completion
GRILLE INSTALLATION
Install the grille assembly and check for proper fit. The grille
is designed to rest on the upper door hinge to minimize the
reveal between the top of the door and bottom of the grille.
To eliminate interference, the grille height can be adjusted.
Loosen the four grille adjustment screws (two on each side)
and adjust the grille height as needed. Refer to the illustra-
tion below.
GRILLE
BACK GRILLE ADJUSTMENT
SCREW SCREWS
FRONT
GRILLE SCREW
Grille height adjustment.
|
subzero.com 29