Sub-Zero Wine Storage Installation Manual page 13

MODEL 427G / 427RG SITE PREPARATION
Anti-Tip Bracket
WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
The back of the anti-tip bracket must be installed 24"
from the front of the unit (without panels).
Use all anti-tip bracket hardware as instructed for wood or
concrete floors.
For wood or concrete floor applications,
IMPORTANT NOTE:
if the #12 screws do not hit a wall stud or wall plate, use the
#8 screws and #12 washers with the wall anchors.
In some installations the subflooring or
IMPORTANT NOTE:
finished floor may necessitate angling the screws used to
fasten the anti-tip bracket to the back wall.
ANTI-TIP HARDWARE
1 Anti-tip bracket
12 #12 x 2 1 / " pan head screws
2
3 3
4 / "–16 x 3 / " wedge anchors
8 4
12 #12 flat washers
4 #8–18 x 1 1 / " truss head screws
4
4 Nylon Zip-it ® wall anchors
WOOD FLOOR
After properly locating the anti-tip bracket in the opening,
drill pilot holes
or wall plate. Use the #12 screws and washers to secure the
brackets. Verify the screws penetrate through the flooring
(610)
material and into wall studs or wall plate a minimum of
3 / " . Refer to the illustration and chart below.
(19)
4
CONCRETE FLOOR
After properly locating the anti-tip bracket in the opening,
drill pilot holes
or wall plate. Drill
a minimum of 1
washers to secure the brackets to the wall, and use the
wedge anchors to secure the brackets to the floor. Verify
the screws penetrate wall studs or wall plate a minimum of
3
/ " . Refer to the illustration and chart below.
(19)
4
ANTI-TIP BRACKET
MODEL
427G and 427RG
A
WALL PLATE
SUBFLOORING
WOOD FLOOR
Wood floor.
3 / " diameter maximum in the wall studs
(5)
16
3 / " diameter maximum in the wall studs
(5)
16
3 / " diameter holes into the concrete
(10)
8
1 / " deep. Use the #12 screws and
(38)
2
A
A
FINISHED
FLOORING
WALL PLATE
SUBFLOORING
CONCRETE
FLOOR
Concrete floor.
subzero.com
3 / "
8
A
13 1 / "
(343)
2
A
FINISHED
FLOORING
1 / "
1
2 (38)
min
|
13