Control A Tuner Or Amplifier - Dish Network HDTV User Manual

Chapter 3
Using the System
Page 70
• Press the RECORD button to start recording on a VCR.
Press the PAUSE button to pause a videotape or DVD. Press
•
this button or the PLAY button to restart the videotape or
DVD.
Note: On some TVs, the presence of fixed images for
•
extended periods of time may cause them to be permanently
imprinted on the screen. Consult your TV user guide for
information on whether this is a problem for your TV, what
operating/viewing restrictions apply to avoid this problem,
and associated TV warranty coverage.
Page Up and Page Down Buttons
Use the UP ARROW and DOWN ARROW buttons to change
channels on a VCR.
Note: These buttons change the off-air channels only.
Number Pad Buttons
• - Use these buttons to enter channel
VCR
numbers.
• - Use these buttons to enter menu
DVD
numbers.

Control a Tuner or Amplifier

Some of the features described below may not apply to your
tuner or amplifier. See the device owner's manual for details
about the device's features. If a remote control button is not
described in this section, it does not work for a tuner or
amplifier.
AUX Mode Button
To use the remote to operate a tuner or amplifier, first set up the
remote to control the device as described on page 65, then press
the AUX mode button to set the remote to AUX mode. The AUX mode
button's backlight turns ON to show that the remote is set to AUX mode.
Make sure to keep the remote in AUX mode to use the buttons as described
in this section.
Power Button
Press the blank POWER button to turn the tuner or amplifier ON
or OFF.