Remote Control Settings - Dish Network HDTV User Manual

Remote Control Settings

Change the Address
When you receive your system, your remote control and receiver have been set
to communicate on address 1. However, because UHF signals travel long
distances and go through walls, a neighbor's UHF Pro remote could control your
receiver by mistake if they are on the same address. Once all connections have
been made, to handle this problem, you can change the address on your remote
control and the receiver as follows:
1. Press
SYSTEM INFO
screen displays and shows the
Write down the address shown: _____________
2. Press and hold the
three seconds, until all of the mode buttons light up, and then let
go of the button.
SAT
3. Use the
NUMBER PAD
and 16, but not the one you wrote in step 1.
Write down the number you entered:___________
4. Press the
POUND
correctly, the
SAT
5. Press the
RECORD
Note : Make sure the
screen is the same as the one you entered in step 3. If it isn't,
Info
the remote cannot control the receiver.
6. Press the SELECT/OK
Checking the Remote Control Address
1. Press and hold the
of the mode buttons light up, and then let go of the
2. Press the
POUND
flash the same number of times as the address number (for
example, three flashes means address 3).
button on the receiver's front panel. The
Remote Address
button on your remote control for about
SAT
buttons to enter any number between 1
(#) button. If you entered the address
mode will flash three times.
button.
Remote Address you see on the
button to close the
SAT mode button for three seconds, until all
(#) button twice. The
SAT
System Info
.
System
System Info screen.
SAT button.
mode button will
Remote Control Settings
Page 17