Receiver Back Panel Connections - Dish Network HDTV User Manual

Receiver Back Panel Connections

Tighten the connections by hand only. If you use a wrench you
might over-tighten the connections and cause damage that would
not be covered by the Limited Warranty.
The receiver back panel has ports you can use to connect the
receiver to other devices (you may not need to use some of these
ports). The back panel also has the power cord and phone jack.
DVI-HDTV/DISH DVI Connector
This digital connection will give you the highest quality video,
both in standard definition and high definition. Use a DVI cable
to make this connection to your HDTV or HD Monitor. If you
use this output for video, you must still connect the audio with
the RCA A O
UDIO
YPbPr Component Connectors
This connection provides another high quality video output for high
definition viewing. Use a YPbPr cable to make this connection to
your HDTV or HD monitor. The cable is color coded to match the
connections on your receiver and your TV. If you use this output for
video, you must still connect the audio with the RCA A
O or the A
UTPUTS UDIO
This output connection is not active if DVI-HDTV/DISH DVI is
connected to a DVI display device.
S-Video
The S-V
connection provides high quality standard definition
IDEO
video output. Use S-Video cables to connect this output to an S-
Video equipped device such as a VCR. If you use this output for
video, you must still connect the audio with the RCA A
O or the A
UTPUTS UDIO
or the A D
UTPUTS UDIO
D O
.
IGITAL UTPUT
D O
.
IGITAL UTPUT
O .
IGITAL UTPUT
UDIO
UDIO
Receiver Back Panel Connections
Page 13