Advertisement
4. Make sure the end of the hose is no higher than the spout, or
water could remain in the tank. Make sure there are no kinks
in the hose (Fig 6).
NOTE: Keep the rubber bung close to the spout.
1. Unplug from the mains socket and empty the tank
(if full).
2. Remove the rubber caps from the bottom of the
appliance by pulling forcefully or using pliers (see
Fig 7/1).
3. Fit the castors by inserting the pins into the holes
(see Fig 7/2).
: While fitting the castors, do not tilt the appliance at
an angle of more than 45°. After fitting the castors, wait
for at least an hour before using the dehumidifier again.
Hygrometer /
thermometer button
: toggles the unit between running and standby mode.
: selects operating modes between dehumidifying, dry, smart and fan.
: selects fan speed.
measured in the room by the appliance. Measurements displayed are indicative only.
increasing or reducing it by steps of 5%.
Decrease
humidity
Fan button
button
: Temporarily displays the temperature and humidity
: Adjusts the percentage of humidity present in the room,
5
Increase
humidity
MODE button
button
Display
ON/Standby button
Advertisement
