Meter Activation And Battery Change - GE GE200 User Manual

Meter Activation and Battery Change

Your GE200 Blood Glucose Meter comes with two CR2032, 3volt, batteries installed. Two new batteries will provide
power to perform approximately 1000 tests under normal use. Press the main button or insert a strip to activate your
meter.
1. Turn the GE200 Blood Glucose 2. Install the batteries. Be sure to
Meter over. Press and slide put the batteries in the correct
the battery cover to open. direction (polarity (+) facing up).
16
3. Slide the battery cover back until
it snaps into place.
4. The GE200 Blood Glucose Meter will enter Self-Testing Mode automatically when replacing the battery (all symbols
will appear on the screen).
5. Press any button to exit the self-test and enter Setting Mode.
6. You must set the time and date when replacing the battery. See Chapter "Setting Up Your Meter - Setting the Date,
Time, and Volume" on page 18. Test results are still stored in the memory.
CAUTION
- Please follow the local regulation to properly discard a used battery.
Meter Activation and Battery Change
17