Table of Contents
Advertisement
T he installation should be done by qualified
service personnel or system installers.
If the ceiling material is not strong enough to
hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
To change the position of the cable, take
away the Hole Cover and pass the cable
through.
Hold the ceiling bracket (located where the arrow points to) and separate it from the main body of
2.
the camera by rotating it anti-clockwise.
Place the separated ceiling bracket so that the "Front" side faces the area to be monitored
3.
and install it with the M4 tapping screws.
Ceiling bracket
tapping screw
To combine the main body with the ceiling bracket, make sure that the pan base fixation screw
4.
face the opposite side of the "Front" side of the ceiling bracket and rotate it clockwise.
Adjust the camera lens to face the area to be monitored and fix the main body and
5.
the dome cover by aligning the grooves and rotating the body clockwise.
tapping
screw
If
you
want
to
install
the
bracket combined, fix it using two tapping screws
at the side of the main body
Original position of
the cable
Cover
Pan Base
fixation
screw
camera
with
the
ceiling
English_13
Hole
Advertisement
Table of Contents
