L2Tpserver - D-Link DFL-260E Reference Manual

3.30.7. L2TPServer

PPPAuthPAP
PPPAuthCHAP
PPPAuthMSCHAP
PPPAuthMSCHAPv2
MPPENone
MPPERC440
MPPERC456
MPPERC4128
DialOnDemand
ActivitySensing
IdleTimeout
Metric
MTU
AutoInterfaceNetworkRoute
MPPEAllowStateful
Comments
3.30.7. L2TPServer
Description
A PPTP/L2TP server interface terminates PPP (Point to Point Protocol) tunnels set up over existing
IP networks.
Properties
Name
IP
Use PAP authentication protocol for this tunnel. User name
and password are sent in plaintext. (Default: Yes)
Use CHAP authentication protocol for this tunnel. (Default:
Yes)
Use MS-CHAP authentication protocol for this tunnel.
(Default: Yes)
Use MS-CHAP v2 authentication protocol for this tunnel.
(Default: Yes)
Allow authentication without Microsoft Point-to-Point En-
cryption (MPPE). (Default: Yes)
Use an RC4 40 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 56 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 128 bit MPPE session key with MS-CHAP or
MS-CHAP v2 authentication protocol. (Default: Yes)
Enable Dial-on-demand which means that the L2TP/PPTP
tunnel will not be setup until traffic is sent on the interface.
(Default: No)
Specifies if the dial-on-demand should trigger on inbound or
outbound traffic or both. (Default: BiDirectional)
Idle timeout in seconds for dial-on-demand. (Default: 3600)
Specifies the metric for the auto-created route. (Default: 90)
Specifies the size (in bytes) of the largest packet that can be
passed onward. (Default: 1456)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
Allow usage of Stateful MPPE (less secure, use only for com-
patibility). (Default: No)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
The IP address of the PPTP/L2TP server interface.
137
Chapter 3. Configuration Reference