L2Tpserver - D-Link NetDefend DFL-210 Cli Reference Manual

3.28.7. L2TPServer

PPPAuthNoAuth
PPPAuthPAP
PPPAuthCHAP
PPPAuthMSCHAP
PPPAuthMSCHAPv2
MPPENone
MPPERC440
MPPERC456
MPPERC4128
DialOnDemand
ActivitySensing
IdleTimeout
Metric
MTU
AutoInterfaceNetworkRoute
MPPEAllowStateful
Comments
3.28.7. L2TPServer
Description
A PPTP/L2TP server interface terminates PPP (Point to Point Protocol) tunnels set up over existing
IP networks.
Properties
Name
Allow no authentication for this tunnel. (Default: No)
Use PAP authentication protocol for this tunnel. User name
and password are sent in plaintext. (Default: Yes)
Use CHAP authentication protocol for this tunnel. (Default:
Yes)
Use MS-CHAP authentication protocol for this tunnel.
(Default: Yes)
Use MS-CHAP v2 authentication protocol for this tunnel.
(Default: Yes)
Allow authentication without Microsoft Point-to-Point En-
cryption (MPPE). (Default: Yes)
Use an RC4 40 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 56 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 128 bit MPPE session key with MS-CHAP or
MS-CHAP v2 authentication protocol. (Default: Yes)
Enable Dial-on-demand which means that the L2TP/PPTP
tunnel will not be setup until traffic is sent on the interface.
(Default: No)
Specifies if the dial-on-demand should trigger on inbound or
outbound traffic or both. (Default: BiDirectional)
Idle timeout in seconds for dial-on-demand. (Default: 3600)
Specifies the metric for the auto-created route. (Default: 90)
Specifies the size (in bytes) of the largest packet that can be
passed onward. (Default: 1456)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
Allow usage of Stateful MPPE (less secure, use only for com-
patibility). (Default: No)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
125
Chapter 3. Configuration Reference