Advertisement
in addition, the RDY light on XL4612RM keypads wlil blink slowly then rapldly in
successlon. On the XL4800LED keypads both the INSTANT and STAY lights will be
ON-The XUBOOLCD keypad will contain the following message;
>>
You cannot exit the presise through an exit/entry zone while the system is
armed in this mode.
10. BYPASS
Bypasses are performed to eliminate burglary zones that are not ready or faulty
from activating the security system.
BYPASS PROCEDURE:
BYPASS [USERJ ZN
Depress the BYPASS key followed by your user code and zone number (l-6) to be
bypassed.
Example:
BYPASS [USER] 2
Will bypass zone 2.
lf the zone has already been bypassed, the sequence wlli unbypass the zone except
If the system is armed and the unbypassed zone is still not ready. Unbypass means
that the zone returns as an active burglary zone.
After the bypass (or unbypass) command has been accepted the unit will emit a
continuous beep and zone or zones that have been bypassed will appear in a slow
blinking mode in the zone status area on the XL461 2RM or XL4800LED keypads.
The XL4800LCD keypad will display the zone bypasses as a secondary display after
the SYSTEM READY or SYSTEM NOT READY as shown below:
BFYRPOANSTSDOOZ::]
if multiple zones are bypassed then more than one display will appear.
11. UNBYPASS
The UNBYPASS function removes an existing bypass from a currently bypassed
zone. After UNBYPASSING a zone, the bypass indication will be removed for that zone
on either the LCD or LED keypad.
The procedure is similar to a bypass.
UNBYPASS PROCEDURE:
BYPASS [USERJ ZN
See bypass description.
12.
USER DEFINITION
Users can be entered or modified directly through the keypad. The STAR XL-461 2
security system can have up to thirty different users. Users number 1 8 number 2 are
known as the master users and are the only users allowed to modify other users.
USER DEFINITION PROCEDURE:
CODE [USER] [US number] [USERID]
where;
g:pl
Is the master user code [User number 1 or User number 2, four
p&mber
]
User number (01-30)
New user ID (0000 - QQQQ).
Note: (') if ambush code capability has been enabled by your installing company then
user number 30 wlil be used as the system ambush code. if an arming only code (maid
code) has been defined by your installer then user number 29 can only arm the system.
Advertisement
