DATALOGIC
!
2.3 OPENING THE SCANNER
Before installing the DS8100 Serial Interface model, it may be necessary to
open the scanner to select the Main interface type and the Multidrop Address
(see par. 2.3.1 and 2.3.2)
Before unscrewing the display panel of the DS8100,
make sure the power supply cable is disconnected
to avoid shock or harm to the operator.
The following operation should be performed by
qualified personnel only.
Refer to the following instructions and Figure 2.2 when opening the reader:
1. The part of the device to be opened is the display panel.
2. Unscrew the six screws to open the scanner.
3. Carefully remove the panel as shown in Figure 2.2.
WARNING
Figure 2.2 - Opening the DS8100
Installation — DS8100 Serial Interface - 2.3
DS8100