Power Supply - Datalogic DS8100 Installation Manual

The laser diodes used in this device are classified as Class 3B laser products
according to IEC 825-1 regulations and as Class IIIb laser products according
to CDRH regulations. As it is not possible to apply a classification label on the
laser diodes used in this device, the following label is reproduced here:
Any violation of the optic parts in particular can cause radiation up to the
maximum level of the laser diode (30 mW at 630~680 nm).

POWER SUPPLY

This scanner is intended to be supplied by either a UL Listed power supply
marked 'Class 2' or 'LPS', output rated 20 - 30 V dc , minimum 1.0 A or by a
UL Listed computer with LPS outputs.
In any case, all models of DS8100 must be supplied by a Class II Power
Supply Unit conforming to the EN 60950 safety regulation.
LASER LIGHT
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAXIMUM OUTPUT RADIATION 30 mW
EMITTED WAVELENGTH 630~680 nm
TO IEC 825-1 (1993)
Laser diode class label
ix