Sd Card Slot; Pir Sensor - Bushnell Trailscout 119700 User Manual

OTHER SETUP NOTES

1. SD CARD SLOT

The unit has a standard SD Card slot. You must push the SD Card in with the SD Card label facing the
Bushnell logo into the SD card slot. Pushing it again will release the SD card, and then you can remove the
SD card from the SD card slot. Insertion or removal of SD card is only recommended when the unit is in
the "OFF" position.

2. PIR SENSOR

The sensor that triggers the trail camera is Passive InfraRed, or PIR. Infrared energy is essentially heat en-
ergy. The PIR detector operates by sensing a change in the infrared level in its detection zone. This zone is
a cone in the center 10 degrees of the camera's field of view. The camera establishes an average long-term
infrared level. When this level increased suddenly the PIR detector signals the camera to record a picture
and/or an event. Because of this effect, the PIR detector will be more sensitive at night, when the average
temperature is lower.
In the Setup mode, you can use PIR sensor to determine the detection zone .When the PIR is sensed, the
PIR Sense Indicator will light. The camera's field of view is a 45 degree cone, centered on the PIR detec-
tion zone.
15