Operating Notes - Bushnell Trailscout 119700 User Manual

2. Power ON and Setup switch summary:
Turn the knob 90°counterclockwise and open the front cover.
Set the K1 to ON position,
Input correct Password. Default password is "0000".
The LCD will display current IMAGE&EVENT counter.
You can press the Up or Down key to see the DATE, TIME, NAME.
If you want to modify DATE, TIME, NAME or password, set K1 to SETUP.
(See instructions)
After finishing SETUP, set K1 back to ON position
The unit will delay 2 minutes before functioning to allow you
to clear out of your area.
The functions of K2, K3, and K4 can be set in the SETUP or
ON Mode.
After finishing SETUP, close the front cover and turn the knob
to 90°clockwise.
Finally, secure the Trail Scout with a padlock.

OPERATING NOTES

a. The LCD showing "RESUME" means the system is active.
b. The LCD showing "ENTER SUSPEND" means the system is going to suspend.
c. After setting K1 to ON, the system will begin working after a 2 minute delay. If there is no activity
sensed in three minutes, the system will go to SUSPEND. When the PIR senses activity, the camera will be
activated immediately.
d. Changing batteries within 20 seconds will avoid the need to reset the date and time.
20
Using the Trail Scout (cont.)
(Note: If the password is entered incorrectly 3
times,the unit will be powered off automatically.
If you want to power ON again you must set K1
back to OFF and then set K1 to ON)
Turn the knob 90°
counterclockwise to open
Turn the knob 90°
clockwise to close