Assembly - Craftsman 919.165190 Owner's Manual

Contents of Carton
1 - Air Compressor
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Rubber Bumpers
2 - Screws, 1/4-20 x .75
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1. Remove all packaging leaving
the air compressor on the pallet.
2. Remove and discard the (4)
screws holding the air compres-
sor to the pallet.
Screws
support one side of the air com-
pressor when removing the pallet
because the air compressor will
have a tendency to tip.
3. Carefully remove the air com-
pressor from the pallet.
D24588

ASSEMBLY

It may be neces-
sary to brace or
Assemble Wheels
one side of the air compressor
when installing the wheels because
the air compressor will have a ten-
dency to tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
Nut
2. Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
vide adequate clearance, stability
or support for pulling the unit up
and down stairs or steps. The unit
must be lifted, or pushed up a
ramp.
Assemble Rubber Feet
1. Attach rubber feet with the
screws provided as shown in
previous figure.
2. Tighten securely.
10- ENG
It will be necessary
to brace or support
Rubber
Feet
Screw
Wheel
Shoulder
Bolt
The wheels and
handle do not pro-