Aastra 6757i CT Installation Manual page 24

Install on the Wall
The 6757i CT IP phone has two pre-drilled wall mounting holes on the back
of the phone.
1. Using the provided wall mount drilling template, locate and mark the
position for the mounting screws on the wall. Depending on the wall
type, you may need to use wall anchors. Both the screws and wall
anchors are included with your phone.
2. Place the wall mount holes on the phone over the screw heads on the
wall and pull down to lock the phone in.
Note: You may wish to purchase a short Ethernet cable from a local supplier for a
wall installation. Also, if 802.3af compliant in-line power is not provided on
your network, and you are installing the 6757i CT on a wall using a PoE in-
line power injector, you may also wish to use an equivalent flat Ethernet
cable rather than the one provided.
3. In the handset cradle, there is a small clip that sits flush with the cradle
surface. Using a small flathead screwdriver, pull the clip up and remove
it from the phone.
4. With the arms on the clip facing you and the flat side of the clip torwards
the phone, turn the clip 180 degrees and reinsert it back into the clip
cavity in the phone's cradle.
18 Model 6757i CT IP Phone Installation Guide
Wall Mount Holes