Using Valet/Service Mode; The Interior Status Indicator; Emergency Disarm Procedure - Code Alarm CA-330 Owner's Manual

Using Valet/Service Mode

Valet Service mode is used to disable your systems security
functions when your vehicle is being serviced or valet parked.
To engage valet/service mode:
1. Turn the ignition key to the RUN position (last position before
start) then OFF three (3) times within 10 seconds.
2. The status indicator (red dashboard mounted LED light)
will emit a double flash sequence to indicate the systems has
entered valet/service mode.
To disengage valet/service mode:
1. Turn the ignition key to the RUN position (last position before
start) then OFF three (3) times within 10 seconds.
2. The status indicator (red dashboard mounted LED light)
will turn off to indicate the systems hasexited valet/service mode.
3. The security system will arm normally the next time the
LOCK button is pressed on the OEM remote control transmitter.

The Interior Status Indicator

The Status Indicator is a high-intensity blue light mounted in a visible
location on the vehicle dashboard. This red light gives a visual
indication of the alarm system's state of operation. Note the chart below:
If the Status Indicator is...
Off
Flashing Slowly
Flashing Very Quickly
Flashing Intermittently
(2 flashes, off, 2 flashes)
On (not flashing)

Emergency Disarm Procedure

If your remote control is lost or fails to function, use this procedure to
disarm the Code Alarm CA-330
1. Use the keys to enter the vehicle.
The alarm will sound once the door is opened.
2. Insert the key into the ignition and turn to the ON position.
3. Locate and press the emergency override button.
The alarm will turn off and then you will be able to
start your vehicle.
CA 330 owners rev 7-04.pmd
....then the Security System
is disarmed
is armed
was triggered in your absence
(see Attempted Intrusion ID - page 4)
is in Valet mode
is in Pre-arm mode
TM
and start your vehicle.
5
5
8/12/2004, 12:26 AM