Table of Contents
Advertisement
f.
Maintain the tool with care.
the Sandpaper sharp and clean. A
properly maintained tool, with sharp,
clean Sandpaper reduces the risk of
binding and is easier to control.
g.
check for misalignment or binding
of moving parts, breakage of
parts, and any other condition
that affects the tool's operation.
If damaged, have the tool serviced
before using. Many accidents are
caused by poorly maintained tools.
There is a risk of bursting if the tool is
damaged.
h.
use only accessories that are
identified by the manufacturer for
the specific tool model. Use of an
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.
Service
a.
Tool service must be performed
only by qualified repair personnel.
b.
When servicing a tool, use only
identical replacement parts. use
only authorized parts.
c.
use only the lubricants supplied
with the tool or specified by the
manufacturer.
Air source
a.
Never connect to an air
source that is capable of
exceeding 200 psi. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
SKU 97956
For technical questions, please call 1-800-444-3353.
Keep
(90 pSI maximum) as marked on the
tool. Always verify prior to using the
tool that the air source has been
adjusted to the rated air pressure or
within the rated air-pressure range.
b.
Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SpEcIFIc SAFETY
INSTRucTIONS
Symbol
n
o
.../min
pSI
ft-lb
BpM
cFM
ScFM
NpT
NpS
chart continued in next column.
SAVE THESE
INSTRucTIONS.
SYMBOLS AND
Symbol Definitions
property or statement
No-load speed
Revolutions or reciprocation per
minute
Pounds per square inch of pressure
Foot-pounds of torque
Blows per minute
Cubic Feet per Minute flow
Cubic Feet per Minute flow at
standard conditions
National pipe thread, tapered
National pipe thread, straight
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
eye protection.
Page 4
Advertisement
Table of Contents
