Air Source; Symbol Definitions - Central Pneumatic 98895 Owner's Manual & Safety Instructions

Service
1. Tool service must be performed only
by qualified repair personnel.
2. When servicing a tool, use only
identical replacement parts.
Use only authorized parts..

Air Source

1. Never connect to an air source
that is capable of exceeding
200 psi. Over pressurizing the tool
may cause bursting, abnormal
operation, breakage of the tool or
serious injury to persons. Use only clean, dry,
regulated compressed air at the rated pressure
or within the rated pressure range as marked
on the tool.
SAVE THESE INSTRUcTIONS.

Symbol Definitions

Symbol property or Statement
n
No-load speed
o
Revolutions or reciprocation
.../min
per minute
pSI
Pounds per square inch of pressure
ft-lb
Foot-pounds of torque
BpM
Blows per minute
cFM
Cubic Feet per Minute flow
Cubic Feet per Minute flow
ScFM
at standard conditions
Page 4 For technical questions, please call 1-800-444-3353.
3. Use only lubricants supplied with the
tool or specified by the manufacturer.
Always verify prior to using the tool that the
air source has been adjusted to the rated air
pressure or within the rated air-pressure range.
2. Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
Symbol property or Statement
NpT
National pipe thread, tapered
NpS
National pipe thread, straight
WARNING marking
concerning Risk of Eye Injury.
Wear ANSI-approved eye protection.
WARNING marking concerning
Risk of Hearing Loss. Wear
hearing protection.
WARNING marking concerning
Risk of Respiratory Injury.
Wear NIOSH-approved
dust mask/respirator.
WARNING marking concerning
Risk of Explosion.
Item 98895