Air Source; Symbol Definitions - Central Pneumatic 68152 Owner's Manual And Safety Instructions

Service
1. Tool service must be performed only
by qualified repair personnel.
2. When servicing a tool, use only
identical replacement parts.
Use only authorized parts.

Air Source

1. Never connect to an air source
that is capable of exceeding
200 psi. Over pressurizing the
tool may cause bursting,
abnormal operation, breakage of the tool or
serious injury to persons. Use only clean,
dry, regulated compressed air at the rated
pressure or within the rated pressure range
as marked on the tool.
SAVE THESE INSTRUcTIONS.
Symbols and Specific Safety Instructions

Symbol Definitions

Symbol property or Statement
n
No-load speed
o
Revolutions or reciprocation
.../min
per minute
Pounds per square
pSI
inch of pressure
ft-lb
Foot-pounds of torque
OpM
Oscillations per Minute
cFM
Cubic Feet per Minute flow
Cubic Feet per Minute flow
ScFM
at standard conditions
Page 4 For technical questions, please call 1-800-444-3353.
3. Use only lubricants supplied with the
tool or specified by the manufacturer.
Always verify prior to using the tool
that the air source has been adjusted
to the rated air pressure or within
the rated air-pressure range.
2. Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
Symbol property or Statement
NpT
National pipe thread, tapered
NpS
National pipe thread, straight
WARNING marking concerning
Risk of Eye Injury. Wear
ANSI-approved eye protection.
WARNING marking concerning
Risk of Hearing Loss. Wear
hearing protection.
WARNING marking concerning
Risk of Respiratory Injury.
Wear NIOSH-approved
dust mask/respirator.
WARNING marking concerning
Risk of Explosion.
Item 68152