Tool Set Up; Operating Instructions - Central Pneumatic 97956 Set Up And Operating Instructions Manual

the air tool to retain pressure and
operate accidentally after the air
supply is disconnected.
Note: Air flow, and therefore tool
performance, can be hindered by
undersized air supply components.
3. The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
4. Make sure the tool's Trigger (19) is in
the off position; refer to "Components
and Controls" section for description
of controls. (See Figure A.)
5. Close the in-line safety valve between
the compressor and the tool.
6. Turn on the air compressor according
to the manufacturer's directions and
allow it to build up pressure until it
cycles off.
7. Adjust the air compressor's output
regulator so that the air output is
enough to properly power the tool,
but the output shall not exceed the
tool's maximum air pressure (90 pSI)
at any time. Adjust the pressure
gradually, while checking the air
output gauge to set the right pressure
range.
8. Inspect the air connections for leaks.
Repair any leaks found.
9. If the tool will not be used at this
time, turn off and detach the air
supply, safely discharge any
residual air pressure, and release
the throttle and/or turn the switch to
its off position to prevent accidental
operation.
SKU 97956 For technical questions, please call 1-800-444-3353.
Note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.

OpERATING INSTRucTIONS

Read the ENTIRE IMpORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and
missing parts. If any problems
are found, do not use tool until
repaired.

Tool Set up

FROM AccIDENTAL
OpERATION:
Turn off the tool, detach the
air supply, safely discharge
any residual air pressure in
the tool, and release the
Trigger (19) before performing
any inspection, maintenance,
or cleaning procedures.
TO pREVENT SERIOuS
INjuRY:
Do not adjust or tamper with
any control or component in a
way not specifically explained
within this manual. Improper
adjustment can result in
tool failure or other serious
hazards.
TO pREVENT
SERIOuS INjuRY
Page 8