Table of Contents
Advertisement
specific tool model, increases the risk of
injury to persons.
Service
a.
tool service must be performed only
by qualified repair personnel.
b.
When servicing a tool, use only
identical replacement parts. use only
authorized parts.
c.
use only the lubricants supplied
with the tool or specified by the
manufacturer.
air source
a.
never connect to an air
source that is capable of
exceeding 200 psi. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury to
persons. Use only clean, dry, regulated
compressed air at the rated pressure or
within the rated pressure range as
marked on the tool. Always verify prior to
using the tool that the air source has
been adjusted to the rated air pressure
or within the rated air-pressure range.
b.
never use oxygen, carbon dioxide,
combustible gases or any bottled gas
as an air source for the tool. Such
gases are capable of explosion and
serious injury to persons.
SaVe theSe
inStructiOnS.
reV 10f
SKU 91773
For technical questions, please call 1-800-444-3353.
SyMbOlS and SpeciFic
SaFety inStructiOnS
Symbol Definitions
Symbol
property or statement
.../min
Revolutions or reciprocation per minute
pSi
Pounds per square inch of pressure
cFM
Cubic Feet per Minute flow
Cubic Feet per Minute flow at standard
ScFM
conditions
npt
National pipe thread, tapered
npS
National pipe thread, straight
WARNING marking concerning Risk of
Eye Injury. Wear ANSI-approved eye
protection.
WARNING marking concerning Risk of
Hearing Loss. Wear hearing protection.
WARNING marking concerning Risk
of Respiratory Injury. Wear NIOSH-
approved dust mask/respirator.
WARNING marking concerning Risk of
Explosion.
Specific Safety Instructions
1.
Read and understand this instruction
manual before product use.
2.
Wear ANSI-approved hearing and eye
protection during use. Wear safety
goggles and heavy duty work gloves
during attachment and removal of
sandpaper.
3.
Clamp workpiece securely before
sanding.
4.
Use this tool with both hands only. Using
tools with only one hand can result in
loss of control.
Page 5
Hide quick links:
Advertisement
Table of Contents
