Assembly And Adjustments - DeWalt DCGG570 Instruction Manual

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury,
turn tool off, push the lock-off button to the OFF position, and
remove the battery pack before making any adjustments or
removing/installing attachments or accessories. An accidental
start-up can cause injury.
Installing a Grease Cartridge (Fig. 2, 6)
1. Pull the grease tube handle (L)
out as far as it will go, then
secure the grease tube rod (M)
into the retaining slot (O) by
moving the rod to the side.
Ensure the rod is placed
securely in the slot to prevent it
from disengaging.
2. Unscrew the grease tube
assembly (N) from the grease
gun.
3. Remove the plastic cap from
the grease cartridge, then insert the cartridge, open end fi rst, into
the grease tube (J).
4. Remove the seal from the other end of the grease cartridge.
5. Thread the grease tube assembly (N) back into the grease gun
and screw it in securely.
6. Release the grease tube rod (M) from the retaining slot (O) and
slowly press it back into the tube.
7. Use the purge valve (X, Fig. 5) to bleed off any air that may be
trapped in the cartridge. Refer to Purging Air Pockets.
IMPORTANT: The grease gun will lose its prime if there are air pockets
in the lubricant.
FIG. 6
O
M
L
12
Removing Empty Grease Cartridge
(Fig. 2)
1. Pull the grease tube handle (L) out as far as it will go, then secure
the grease tube rod (M) into the retaining slot (O) by moving the
rod to the side. Ensure the rod is placed securely in the slot to
prevent it from disengaging.
2. Unscrew the grease tube assembly (N) from the grease gun and
remove.
3. Gently release the grease tube handle (L) to expel the empty
cartridge from the grease tube.
Filling the Grease Gun from a Bulk
Container (Fig. 2, 5–9)
PREPARING THE GREASE
GUN FOR SUCTION AND
FILLER PUMP FILLING
(FIG. 1, 7)
NOTE: Be sure the grease
gun is empty of grease before
beginning this process.
1. Unscrew the grease tube
(J) from the grease gun
assembly (N).
2. Unscrew the grease tube
cap (K) from the grease
tube (J) and pull out the
grease rod (M).
3. Using your thumb and
forefi nger, fl ip the rubber
seal (GG) from the rear to
the front. Refer to Figure 7.
FIG. 7
Rubber Seal Position
for Grease for Filling from
Cartridge Bulk Container
GG