a2b Kuo+ Owner's Manual page 16

6.4..4 Changing Power modes:
The electrical system of the A2B Kuo+ is offering you six power
modes.
Mode 0 is the mode without power supply from the system
(rides without power assistance). Mode 1 to 5 gives you power
assistance with Mode 1 giving the lowest assistance, ranging up
to Mode 5 which maximum assistance, enabling you to reach a
maximum speed up to 30.2 km/h = 18,7 mph (Europe 25 Km/H
=15.5Mph) pending on various external factors as e.g. rider weight,
wind, terrain etc.
The default Mode is Mode1; each time you press the Mode
button increases the assistance by one level. Once you pass Mode
5 it returns back to Mode 0 without any assistance.
6.4.5. Riding speed indicator
Default speed unit is KM/H, by pressing the info button
interchanges between km/h and mph.
6.4.6. Battery Management System (BMS)
BMS system will indicate battery state of charge in bars, the state
of charge in percent, the total battery discharge cycles (CYCLES),
the battery voltage (V) and the battery temperature (°C).
After switching on the system, push down
16
time the screen will show the discharge cycles; push down
again then it will show the voltage of battery.
One more time press down
be shown.
For returning back to the main interface press at the
same time
6.4.7. TRIP and ODO indicator
Default setting after switch on the display is TRIP. Pressing the
button alternates to ODO mode to show the total accumulated
mileage.
To interchange between these two just press
6.4.8. Backlight function
its
Switch on the display, hold the
on the backlight.
To switch off the backlight press the
seconds.
6.4.9. Standby mode
With the system switched on and without any power output for 10
and at same minutes the system will automatically go into the Standby mode in
order to save energy.
the temperature of the battery will
and .
button for 3 seconds switching
button again for in 3
Owner`s manual
button.