SMART Board Board 3000i Installation Manual page 14

If you wish to connect both a VCR and a DVD player to the projector, you must use the composite
video cable for the VCR and the S-video cable for the DVD player. If both are connected, pressing
the VCR/DVD Player button alternates the display source between the VCR and the DVD player.
There is a three-second delay before the alternate display source appears.
Although there is only a single external audio connection, you can link the VCR and DVD player
audio connections. This linked audio connection makes the audio source switch automatically
when you switch the video sources.
When you switch to another source (such as the internal computer), and then press the VCR/DVD
Player button, the last active video source appears.
To connect a VCR to the 3000i
1. Connect an RCA composite video cable inside the cabinet to the VCR's Video OUT jack. This
jack may be labeled "To Monitor."
NOTE: If the VCR has an S-video output, you can connect the S-video cable bundled inside
the cabinet to the VCR. However, if you use the S-video cable to connect to the VCR, you
won't be able to use this cable to connect to a DVD player.
2. Connect the RCA cables inside the cabinet to the VCR's RCA Audio (or Audio OUT) outputs.
Keep the right and left channel connections correct for stereo sound.
NOTE: You can't connect these audio cables to both the VCR and the DVD player. However,
you can link the audio connections of the DVD player and VCR, as described below.
3. Connect the VCR's power cable to an available power outlet in the cabinet.
To connect a DVD player to a 3000i
1. Connect the S-video cable inside the cabinet to the DVD player's S-video OUT receptacle.
NOTE: Alternatively, you can connect the RCA composite video cable bundled inside the
cabinet to the DVD player. However, the S-video cable provides better image quality than the
composite video cable.
2. Connect the RCA audio cables inside the cabinet to the DVD player's RCA Audio (or Audio
OUT) outputs. Keep the right and left channel connections correct for stereo sound.
NOTE: You can't connect these audio cables to both the VCR and the DVD player. However,
you can link the audio connections of the DVD player and VCR, as described below.
3. Connect the DVD player's power cable to an available power outlet in the cabinet.
8 Setting Up the 3000i 99-00224-20 REV A0