About The Setting Utility Software; Changing Talk Over Function Setting/Level; Adjusting Crossfader Cut Lag - Pioneer DDJ-SZ Operating Instructions Manual

Dj controller

Hide thumbs Also See for DDJ-SZ:

Operating instructions manual (20 pages)

Operating instructions manual (16 pages)

Table Of Contents

Table of Contents

Enlarged version

Changing the talk over function setting

About talk over mode

The talk over function has the two modes described below.

Advanced talk over mode: Sound other than the microphone channel is output with

only the midrange attenuated per the talk over level setting.

Normal talk over mode: Sound other than the microphone channel is output attenu-

ated per the talk over level setting.

! By default, the advanced talk over mode is set.

Press the [GRID SLIDE] button of the left side deck.

! [GRID SLIDE] button lit: Advanced talk over mode

! [GRID SLIDE] button off: Normal talk over mode

Changing the talk over function level

Sets the talk over function's sound attenuation level.

! By default, the level is set to -18 dB.

Press the performance pad on the left side to select a setting.

The currently selected setting can be understood by looking at which pad lights.

–6 dB

Adjusting the crossfader cut lag

Adjust the play (cut lag) on both edges of the crossfader. It can be adjusted between

0 (0.74 mm) and 52 (5.94 mm) in units of 0.1 mm.

! By default, it is set to 6 (1.34 mm).

Turn the rotary selector on the left deck.

The current setting (0 to 52) is displayed by the lit condition of the channel level

indicator.

! Number of lit segments of the [CH3] channel indicator: Tens

! Number of lit segments of the [CH1] channel indicator: One's place

Setting the microphone output of the booth

monitor

! By default, it is set to output microphone sound from the [BOOTH OUT]

terminal.

Press the [BACK (VIEW)] button of the left side deck.

! [BACK (VIEW)] button lit: Outputs microphone sound from the [BOOTH OUT]

terminal

! [BACK (VIEW)] button off: Does not output microphone sound from the [BOOTH

OUT] terminal

Frequency

–12 dB

–18 dB

–24 dB

Changing the peak limiter setting

Lessens sudden, unpleasant digital clipping of the master output.

! By default, the peak limiter is set to enabled.

Press the [LOAD PREPARE (AREA)] button of the left side deck.

! [LOAD PREPARE (AREA)] button lit: Peak limiter enabled

! [LOAD PREPARE (AREA)] button off: Peak limiter disabled

Adjusting the brightness of jog ring

You can adjust the brightness of the illumination around the jog dial.

! The same setting is applied to the jog dials on the left and right decks.

! By default, it is set to bright light.

Press the top of the jog dial.

Each time the top of the jog dial is pressed, the setting changes.

The brightness can be set in three levels: light, dark, and off. The current setting can

be understood by the jog ring lit condition.