Skoda Octavia 2014 Owner's Manual page 173

Note
If you lose the key, please get in touch with a specialist garage.
Adjusting the ready position
Fig. 167 1st Step: Key Version 1 / key Version 2

Read and observe and
The ball rod must be set to the ready position prior to installation
Correctly adjusted ready position.
If it is not in the ready position, then it must be set to the ready position as
follows.
1st Step - applies to the key version 1
›
Remove the cap from the lock
›
Insert key into the lock so that the green marking is pointing upwards.
A
›
Turn key in the direction of arrow
A
upwards » Fig. 167.
170
Driving
Fig. 168
2nd step: both key versions
on page 169 first.
so that the red marking is pointing
1
1st Step - applies to the key version 2
›
Remove the cap from the lock
›
Insert key
B
›
Turn the key in the direction of arrow
shows up » Fig.
2nd Step - applies to both key versions
›
Grip the tow bar below the protective cap.
›
Push release pin
ously push operating lever
stop » Fig. 168.
Operating lever
Correctly adjusted ready position
Fig. 169 Ready position: Key Version 1 / key Version 2 / position of the
lever and the release bolt with two key versions

Read and observe
Correctly adjusted ready position
» page 170,
Applies to key version 1 - the red marking on key

Applies to key version 2 - the eye of the key

Operating lever

The trigger pin

The ball bar is thus set ready for installation.
CAUTION
In the ready position, the key cannot be removed nor turned into a different
position.
into the lock so that the eye of the key is pointing downwards.
so that the conclusions release
B 2
167.
in the direction of arrow
C 3
in the direction of arrow
D
remains locked in this position.
D
and on page 169 first.
» Fig. 169
is locked in the lower position.
C
can be moved.
D
to the stop, and simultane-
to the
4
is pointing upwards.
A
is pointing upwards.
B