The socket only works if the ignition is switched on.
Use
›
Fold out the lid on the power socket in the direction of the arrow
›
Connect the plug for the electrical appliance to the socket.
The power socket can only be used when the ignition is switched on
When the plug on the electrical appliance is inserted into the power socket,
the child safety lock is released, and the power socket is activated.
Warning light
›
Permanent green light: The power socket is activated.
›
Flashing red light: The power socket is temporarily deactivated.
The power socket is deactivated automatically when the amperage is too high,
the temperature is too high or the battery charge state is too low.
If disabling reasons no longer exist, the socket is automatically activated. Then
re-activate connected devices which are switched on
WARNING
The power socket can only be used for connecting approved electrical ac-
■
cessories with a two-pin 230V plug, with a total power uptake of up to
150 watt.
Improper use can lead to serious injury or fire. Therefore, when leaving
■
the vehicle, never leave people who are not completely independent, such
as children, unattended in the vehicle.
Safely stow away all connected devices during the journey to prevent
■
them from being thrown around the interior in the event of a sudden brak-
ing manoeuvre or an accident – risk of death!
Do not pour liquids into the power socket – risk of death! If fluid does
■
manage to get into the power socket, completely dry out the socket before
reuse.
The connected devices may warm up during operation – risk of injury or
■
fire!
The child lock on the power socket is unlocked when using adapters and
■
extension cables which carry volts – risk of injury!
Do no insert any conductive objects into the contacts of the power sock-
■
et, e.g. knitting needs – risk of death!
102
Using the system
Place the connector on the electrical device into the power socket as far as it
■
can go to create a connection between the contacts.
» Fig.
95.
If the connector of the electrical device is not inserted fully into the power
■
socket, the child safety lock might release, and the power socket be activated.
»
.
The electrical device is still not supplied with power.
The socket is temporarily disabled at engine start-up and the indicator light
■
flashes red. After starting the engine, the power socket is re-activated auto-
matically.
Do not connect any lamps with neon filaments to the power socket - risk of
■
damaging the lamp.
A larger current surge may arise in some power supplies (e.g. for notebooks)
■
when connecting them to the power socket- this will automatically deactivate
the power socket. In this case, disconnect the power supply from the consum-
er and connect the power supply to the power socket first, followed by the
consumer.
»
.
The connected appliances may behave differently to when connected to the
■
mains.
Observe the operating instructions for the connected devices!
■
Removable through-loading bag
Fig. 96 Tighten ribbon / secure through-loading bag
The removable through-loading bag (hereinafter referred to only as a through-
loading bag) is used exclusively for transporting skis.
Stowing the through-loading bag and skis
›
Open the boot lid.
CAUTION
Read and observe
on page 94 first.