Table of Contents
Advertisement
Multi-function pocket
Fig. 112 Pull out / insert / push in / remove multi-function pocket
Read and observe
and
The multifunction box under the roll-up luggage compartment cover is provi-
ded for the storage of clothing and light objects with no sharp edges.
Extending
›
Fold down the front hooks on both sides of the luggage compartment in the
direction of arrow
» Fig.
112.
1
›
Grasp the rear bar
with both hands and withdraw the pocket in arrow di-
A
rection
.
2
›
Place the rear bar onto the two hooks that are folded forward in the direc-
tion of the arrow
all the way to the stop.
3
Pushing in
›
Remove the rear bar from the hook in the direction of the arrow
›
Push in the multi-function pocket in the direction of the arrow
›
Place the rear bar against the front bar and press them together at both
ends
.
B
110
Using the system
on page 103 first.
›
The front hooks on both sides of the luggage compartment fold back oppo-
site to the direction of arrow
Removing/inserting
›
Remove the roll-up luggage compartment cover
›
Remove the multi-function pocket from the recesses in the direction of the
arrow
» Fig.
6
Insertion takes place in reverse order.
›
When inserting, push the end of the bar marked into the right receptacle
and the end of the bar marked into the left receptacle. The arrows should
be pointing forward.
CAUTION
The maximum permissible load of the multifunction box is 3 kg.
Class N1 vehicles
Read and observe
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.
Variable loading floor in the luggage compartment (Estate)
Introduction
This chapter contains information on the following subjects:
Positions of the variable loading floor
Fold up variable loading floor
Dividing the luggage compartment
CAUTION
The maximum permissible load of the variable loading floor is 75 kg. For the
» Fig.
112.
4
transport of heavy loads, adjust the variable loading floor in the lower posi-
.
5
tion
» page
111.
.
1
112.
and
on page 103 first.
» page
108.
111
111
112
Advertisement
Chapters
Table of Contents
