Installing The Guide Tube - Frank PYTHON C 048666 Operating Instructions Manual

5

Installing the guide tube

Note: The Python C is delivered with the guide tube (1) removed.
Caution!
Injury to the operator or other persons could occur or damage could occur if the machine
starts up unintentionally. Disconnect the machine from the power supply before working
on the machine!
Instructions:
1. Insert the guide tube (1) into the guide tube support (7). The curved section of the tube must
face toward the motor. Clamp the guide tube by means of the clamping lever (6) located on
the guide tube support.
2. Fit the connector (8) into the both screws of th pull rod
3. Move the main lifting lever (2) into the rear position to raise the sanding drum from the floor.
4. Tighten both wing nuts
10
Operating instructions
Parquet floor sander Python C 3,2kW/50Hz
with gentle lifting lever
02/2008