Installing The Guide Tube - Frank COBRA C Operating Instructions Manual

5

Installing the guide tube

Note: The COBRA C is delivered with the guide tube (1) removed.
Caution!
Injury to the operator or other persons could occur or damage could occur if the machine
starts up unintentionally. Disconnect the machine from the power supply before working
on the machine!
Instructions:
1. Insert the guide tube (1) into the guide tube support (7). The curved section of the tube must
face toward the motor. Clamp the guide tube by means of the clamping lever (6) located on
the guide tube support.
2. Position the pair of bores in the control rod connector (8) over the pair of bores in the control
rod (5). The control rod connector has to lie close on the right side of the control rod. Screw
together the parts with the two wing screws (4).
3. Move the main lifting lever (2) into the rear position to raise the sanding drum from the floor.
10
Operating instructions
Parquet floor sander COBRA C
with gentle lifting lever